BN Products BNCE-30-24V, Руководство по эксплуатации и инструкция

Страница: 7 / 16

Page | 7
It is also recom m ended that the cutting blade be rem oved and inspected for any m ateri-
als that did not exit out the chip exhaust area. This should be done after 4-8 hours of use.
Most m aterial cutting chips would norm ally exit out the chip exhaust area and into the
Cutting Chip Catch Bag. It is recom m ended that the Cutting Chip Catch bag be em ptied
when it becomes 2/3 full of cut material.
RB -BN CE-3 0 B la d e
The Blade for the BNCE-30 -24V Cutting Edge Saw™ should be replaced when the blade is
dull or chipped and a noticeable increase in cutting tim e has occurred.
To change the Blade, rem ove the screws that hold the Blade Cover to the Body. Rem ove
the cover and unscrew the four bolts holding the blade to the Hub. The replacem ent
blades that you purchase have new screws to be used when installing the new blade. Make
sure that when you rem ove the blade you clean out any m etal debris that has not escaped
the tool.
Ge n e ra l Op e ra tin g Ca u tio n s
The following describe the general cautions for operating the tool. Always observe the
cautions stated in each item .
• Do not press the operation switch if the tool is pointed towards anyone. Operating the
tool by holding it toward anyone m ay cause injury from contact with the blade.
• Do not use the Cutting Edge Saw for purposes it is not intended.
• Do not use the tool for lifting or ham m ering etc. instead, only use this tool for cutting.
Otherwise, the m ain unit m ay be broken or dam aged, causing injury.
Charger for BNCE-24VLI Battery
Model BNCE-24VCHGR
Input A.C. 120 V 50 -60 Hz
Output D.C. 14.4V - 21.6V
Weight 1 lbs. (.45 kgs)
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS — This m anual contains im portant safety and operating
instructions for battery charger. Before using battery charger, read all instructions and
cautionary m arkings on (1) battery charger, (2) battery, and (3) product using battery.