BMW Z3 COUPE, Руководство пользователя

Страница: 147 / 198

147 n
Index
Data
Te
chnolog
y
Repairs
Car care
Controls
Overview
Lamps and bulbs
The lamps and bulbs make essential
contributions to the safety of your vehi-
cle. Therefore, comply fully with the fol-
lowing instructions during bulb replace-
ment. If you are not familiar with any of
the procedures, consult your BMW
center.
Do not touch the glass portion of
a new bulb with your bare hands
since even small amounts of impurities
burn in to the surface and reduce the
service life of the bulb. Use a clean
cloth, paper napkin, or a similar mate-
rial, or hold the bulb by its metallic
base.
<
A replacement bulb set is available from
your BMW center.
Before performing any work on
the electrical system, switch off
the affected accessories or disconnect
the cable from the negative terminal of
the battery. Failure to do so could result
in short circuits in the electrical system.
To prevent injuries and damage, com-
ply with any instructions provided by
the bulb manufacturer.
<
The illustration depicts the right side
of the engine compartment.
1 High beams
HB3, 65-watt bulb
2 Low beam headlamps
HB4, 55-watt bulb
The bulb is pressurized. There-
fore, wear safety glasses and pro-
tective gloves. Failure to comply with
this precaution could lead to injury if the
bulb is accidentally damaged during re-
placement.
<
367us067
1 Turn the bulb holder with the bulb to
the left and remove toward the rear.
2 Pull off the plug.
3 Push the new bulb holder with bulb
onto the plug – ensure proper lock-
ing.
4 Reinstall in reverse order.
When cleaning the headlamps,
please observe the following:
>
Do not clean by wiping with a dry
cloth (this causes scratches). Never
use abrasives or strong solvents to
clean the covers.
>
Remove dirt and contamination (such
as insects) by soaking with BMW Car
Shampoo and then rinsing with plenty
of water.
>
Always use a deicer spray to remove
accumulated ice and snow – never
use a scraper.
<