BMW C 650 Sport, Руководство пользователя для мотоциклиста

Страница: 109 / 170

ATTENTION
Jump-starting with a voltage
higher than 12 V.
Damage to the motorcycle's
electronics.
The battery of the donor ve-
hicle must have a voltage of
12 V.
Make sure ground is level and
firm and place Maxi-Scooter on
its center stand.
Removing the front fairing
(
110).
Removing fairing side panel
(
110).
Begin by connecting one end
of red jumper cable to positive
terminal of your motorcycle and
other end to positive battery
terminal of other vehicle.
Begin by connecting one end
of black jumper cable to nega-
tive terminal of your motorcycle
with a suitable grounding point
or to negative battery terminal
of other vehicle.
Allow engine on support mo-
torcycle to run while jump-
starting.
Start engine of vehicle with dis-
charged battery in usual way;
if engine does not start, wait
a few minutes before repeat-
ing attempt in order to protect
starter motor and donor bat-
tery.
Allow both engines to run for
several minutes before discon-
necting the jump lead.
First disconnect the jump lead
from the negative terminal or
ground support point, then
from the positive terminal or
positive battery connection
point.
NOTICE
To start the engine, do not use
start sprays or similar items.
Install fairing side panel
(
111).
Fitting the front fairing
(
112).
Battery
Maintenance instructions
Correct battery maintenance
combined with proper charging
and storage procedures extends
the battery's service life, and is
also required for warranty claims.
Compliance with the points be-
low is important in order to maxi-
mize battery life:
Keep the surface of the battery
clean and dry
Be sure to read and comply
with the instructions for charg-
ing the battery on the following
pages
Do not turn the battery upside
down
8
107
z Maintenance