EN/19
Retrofit / Installation kit No. 65 12 0 029 883 (others see cover sheet)
Issue date: 05.2002
Installation Instructions No. 01 29 0 029 576
9.
To install the CD changer
(cars with an on-board monitor and without a DSP amplifier only)
0
The installation of the power supply cable
A
for the CD changer is only necessary, if the
black 3-pin socket casing
X18180
on the
power supply for the CD changer is not tied
back near
X322
on the audio wiring
harness.
0
Disconnect the white 12-pin plug connector
X322
.
Disconnect the existing socket contact from slot
PIN4
, white/grey/yellow cable on the white 12-pin
socket casing
X322B
.
Connect branch
A1
, 1-pin socket contact, white/
grey/yellow cable on the power supply cable
A
to
the white 12-pin socket casing
X322B
in slot
PIN4
.
Connect the supplied 1-pin black socket casing to
the disconnected socket contact and connect it to
branch
A1
, black 1-pin plug casing, white/grey/
yellow cable.
0
Disconnect the existing socket contact from slot
PIN1
, red/green cable on the white 12-pin socket
casing
X322B
. Connect branch
A2
, 1-pin socket
contact, red/green cable on the power supply
cable
A
to the white 12-pin socket casing
X322
in
slot
PIN1
.
Connect the supplied 1-pin black socket casing
on to the disconnected socket contact and
connect it to branch
A2
, black 1-pin plug casing,
red/green cable. Remove the left tail light.
0
Screw branch
A3
, cable eyelet, 6 mm in diameter,
brown cable on the power supply cable
A
, to earth
post
X13016
in the boot at the rear left on the side
panel.
Lay branch
A4
, black 3-pin socket casing on the
power supply cable
A
, to the installation location of
the CD changer.
X322
X18180
F 53 0773 B
A1
X322
A 1
2
A1
PIN4
X322B
F 53 00774 B
1
A2
X322
A2
A
PIN1
2
X322B
F 53 0775 B
X13016
A3
A
A4
F 53 0776 B