If a tire inflation pressure of 2 bar cannot be
reached, contact your service center.
Stowing the Mobility System
1.
Unscrew the filling hose of the sealant con‐
tainer from the wheel.
2.
Unscrew the connection hose of the com‐
pressor from the sealant container.
3.
Connect the filling hose of the sealant con‐
tainer previously connected to the tire
valve with the available connector on the
sealant container.
This prevents leftover sealant from escap‐
ing from the container.
4.
Wrap the empty sealant container in suita‐
ble material to avoid dirtying the cargo
area.
5.
Stow the Mobility System back in the vehi‐
cle.
Distributing the sealant
Immediately drive approx. 5 miles/10 km to en‐
sure that the sealant is evenly distributed in the
tire.
Do not exceed a speed of 50 mph/80 km/h.
If possible, do not drive at speeds less than
12 mph/20 km/h.
To correct the tire inflation pressure
1.
Stop at a suitable location.
2.
Screw the connection hose of the com‐
pressor directly onto the tire valve stem.
3.
Insert the connector into the power socket
inside the vehicle.
4.
Correct the tire inflation pressure to
2.5 bar.
▷
Increase pressure: with the ignition
turned on or the engine running, reel
on the compressor.
▷
To reduce the pressure: press the but‐
ton on the compressor.
Continuing the trip
Do not exceed the maximum permissible
speed of 50 mph/80 km/h.
Reinitialize the Flat Tire Monitor.
Reinitialize the Tire Pressure Monitor.
Replace the defective tire and the sealant con‐
tainer of the Mobility System as soon as possi‐
ble.
Snow chains
Fine-link snow chains
Only certain types of fine-link snow chains
have been tested by the manufacturer of the
vehicle, classified as road-safe and approved.
Information about the approved snow chains
are available from the service center.
Use
Use only in pairs on the rear wheels, equipped
with the tires of the following size:
▷
255/40 R 19
▷
255/35 R 20
Follow the snow chain manufacturer's instruc‐
tions.
Make sure that the snow chains are always
sufficiently tight. Retighten as needed accord‐
ing to the chain manufacturer's instructions.
Do not initialize the Flat Tire Monitor after
mounting snow chains, as doing so may result
in incorrect readings.
Do not initialize the Tire Pressure Monitor after
mounting snow chains, as doing so may result
in incorrect readings.
When driving with snow chains, if needed
briefly activate M Dynamic Mode.
Maximum speed with snow chains
Do not exceed a speed of 30 mph/50 km/h
when using snow chains.
Seite 184
Mobility
Wheels and tires
184
Online Edition for Part no. 01 40 2 954 258 - II/15
Содержание 2015 M6 Coupe
