BMS EASY-CHECK FN, Руководство по эксплуатации

Страница: 4 / 10

Function Modes
Switch on the device by pressing the key until
<on>
is displayed. Release the key.
While switching on and pressing the key for a longer time the software version and the
status of the Lock Function for calibration (from software 13.1) are displayed.
When you now press the key once again for a longer time the following functions will ap-
pear one after another:
Sto = Store readings in the Data Memory
StA =
Display Statistics
Prn
= Print or activate the Serial Interface
IcL
= Clear the last reading
cLr
= Clear the whole Data Memory
nFE
= Base material recognition
NFE = recognizes exclusively non-ferrous metals
un
= Change the unit of measurement (µm / mils)
rES
= Switch over the resolution from 1.0 µm to 0.1 µm
By pressing the key the mode selected is confirmed.
Operation Of The Function Modes
<Sto> Store readings in the Data Memory
To store readings in the memory for further evaluation press the key until <Sto> is dis-
played.
Now release the key and wait until
<on> is flashing. Confirm by pressing the key again.
The data memory is activated and all subsequent measurements will be stored. The sym-
bol
<STORE> is displayed to make evident that the memory is switched on.
Capacity of the data memory : 1000 readings
When the memory has reached its capacity limit the symbol
<FUL> is displayed.
As soon as the device is switched off the memory mode is deactivated.
<StA> Display Statistics
The readings stored in the data memory are evaluated as follows:
No. - Number of readings stored
MIN - Lowest reading stored
MAX - Highest reading stored
MEAN - Mean value
STD.DEV. - Standard deviation
Press the key until the symbol
<StA>
appears. Now wait until
<StA>
is flashing and con-
firm by pressing the key again. The statistics values are displayed one after another.
Operation
EASY- CHECK FN
Manual
Rev:00
4 / 10