BMPRO SwayControl, Руководство пользователя

Страница: 6 / 20

6
Installation Instructions
PERSONNEL
The SwayControl is a safety device which is required to be installed in the caravan/
trailer by suitably qualified service personnel.
To operate correctly, the SwayControl must be securely fastened onto a vertical surface
of a steel trailer. Do not fasten the SwayControl to any other trailer surface that flexes
or moves from wind such as plastic covers or plastic walls.
ORIENTATION
Ensure that the SwayControl is mounted in the correct, UP direction.
The centre of the SwayControl (marked by the orange dot on the SwayControl label)
must be positioned over the centre line of the caravan/trailer.
The bottom edge of the SwayControl (as indicated by the orange line on the bottom of
the SwayControl label) must be mounted parallel to the trailer beam axle.
Figure 2 further demonstrates guidance on mounting the SwayControl to the trailer.
WARNING
For proper operation of the SwayControl , ensure that the electric brakes are
adjusted and maintained in accordance with the manufacturer’s recommendations
in the electric brakes owner’s manual.
MOUNTING LOCATION CONSIDERATIONS
The suggested location for mounting the SwayControl is on the first trailer frame
crossmember, approximately 0.3 to 3.0m behind the trailer hitching point.
The SwayControl must be mounted in the correct orientation (as indicated on the
label), on either the “leading” or “trailing” edge of the crossmember. “Trailing” edge is
preferred, as it provides the best protection from road debris.
WARNING
DO NOT spray high pressure water on the SwayControl . The SwayControl is a
weather sealed, water resistant unit, but it is not designed to withstand direct, high
pressure spray from a power washer.