BMPRO SwayControl, Руководство пользователя

Страница: 17 / 20

17
Troubleshooting with the Status Light
Need more help troubleshooting your SwayControl ? Contact our customer service
team on line at https://teambmpro.com/technical-support/ or give us a call on (03)
9763 0962.
Status Light Flash
Sequence
Condition or Fault Solution
Solid GREEN pulsing Normal operation.
1 GREEN flash
Module reset to manufacturer
default values. Keep trailer still for
30 seconds (minimum) then drive
normally.
If module does not return to normal
solid GREEN pulsing light after
3 system restarts, have the unit
checked at a service centre.
Continuous RED,
GREEN flash
Driving on rough terrain and sway
control of trailer is disabled.
Sway control of trailer is
automatically disabled when driving
on rough terrain. Unit will return
to normal operation (GREEN light)
when not on rough terrain.
No Light Unit in “sleep” mode
Activate manual override on the
brake controller to “wake-up” unit
No Light
No power after “wake-up” from
brake controller
Check quality of power, ground and
brake controller wire connections.
Check for any blown fuses on the
tow vehicle and trailer.
No Light
Over voltage, greater than 20V
detected
Check power source voltage,
correct voltage is 12-15V.
No Light Low voltage, less than 3V detected
Check power source voltage,
correct voltage is 12-15V.
Check quality of power and ground
connections.
1 RED flash System malfunction Service centre repair required.
2 RED flashes
Sensor malfunction - no sway
control of trailer
Service centre repair required.
3 RED flashes Left side brake short
Correct the short in left side brake
wiring.
4 RED flashes Right side brake short
Correct the short in right side brake
wiring
Fast RED flashing Low voltage, between 3 and 6V
Check quality of power and ground
connections.