BMPRO SwayControl, Руководство пользователя

Страница: 15 / 20

15
Final Brake Wiring Check and Start Up
To check that the SwayControl is wired correctly:
1. Refer to figure 10 to verify correct wiring on the left-hand side of the trailer.
Ensure that ONLY the
PURPLE
and
WHITE
wires from the
SwayControl
are
connected to the left side trailer brakes and are wired in parallel and not in series.
2. Refer to figure 10 on the following page and verify correct brake wiring on the
right-hand side of the trailer.
Ensure that ONLY the
PINK and WHITE from the SwayControl wires are connected
to the right side trailer brakes and are wired in parallel and not in series.
After performing the final brake wiring check, the
SwayControl
is ready for start-up.
The operational status of the SwayControl is indicated by the LED Status Light. The
SwayControl is in sleep mode if the LED Status Light is off (dark). The SwayControl will
start-up (wake-up) when voltage is applied to the BLUE wire.
Once the trailer is connected to the tow vehicle, apply the manual override on the trailer
brake controller in the tow vehicle. If the
SwayControl
is installed correctly, the LED
Status Light should start flickering
GREEN
.
If the LED Status Light does not come on when applying the manual override on the
brake controller, refer to
Troubleshooting with the Status Light to diagnose potential
faults in the installation of the SwayControl .