BMPRO JHub, Руководство пользователя

Страница: 28 / 32

Bluetooth pairing was performed using the tablet setting and not through
the JHub App.
The JHub App will not work properly if the JHub Tablet is paired to the ControlNode
directly from the tablet’s Settings menu.
Cycle the tablet’s Bluetooth off and on through the tablet’s Settings menu (Figure 7)
then follow the instructions in this manual to pair the JHub Tablet to the ControlNode
I can’t scan for a ControlNode and the list of available ControlNode is empty?
The Bluetooth on the JHub Tablet might be turned off. Ensure the Bluetooth is turned
on.
Alternatively, the ControlNode you are scanning for may already be paired to and in
Bluetooth range with four mobile devices.
If this is the case, when you press the pairing button on the ControlNode it will flash
orange for one second instead of green for 30 seconds.
Hold the Pairing Button on the ControlNode down for 10 seconds to remove all
paired devices from the ControlNode memory (the LED Status Indicator on the
ControlNode will flash red). The ControlNode will then automatically flash green for
up to 30 seconds to indicate that it’s ready to pair. You may now use the JHub App to
scan for the ControlNode.
I’ve paired to the ControlNode, why is the Pairing Status icon on the JHub App red?
Check the following:
1.
Ensure the JHub Tablet is turned on and is located in its mount or within the range
of ControlNode.
2.
Ensure the J35 is powered from either the mains, AUX or solar input.
3.
Ensure the switch connected to the J35 Load Isolation input is not activated as
this will turn power to the ControlNode off, meaning the ControlNode cannot talk
to the JHub Tablet.
4.
Ensure the J35 is not in Storage Mode as this will also turn power to the
ControlNode off.
If the J35 is in Storage Mode, the operational status indicator on the J35 will emit a
single yellow flash. Connect the J35 to a power source and begin battery charging.
Bluetooth will automatically reconnect once the caravan’s battery voltage exceeds
the Storage Mode threshold.
If the above does not work, cycle the tablet’s Bluetooth off and on through the
tablet’s Settings menu (figure 7). Then follow the instructions in this manual to pair
the JHub Tablet to the ControlNode.
28