BML dCam3, Инструкция по эксплуатации

Страница: 5 / 54

- 3 - - 4 -
is detected within the camera’s field of vision. When all movement ceases, the re-
cording will stop after 10 seconds and be saved. Should you stop any recordings
manually, or should the camera switch off, then the motion detector will deactivate.
- Date stamp – Recordings are marked with actual times and dates.
- Record audio – The microphone can be switched on and off here.
- G-sensor – If the G-sensor iss activated, then, in case of any collision, it will auto-
matically lock the current recording and protect against it being overwritten. It is
possible to set the sensitivity on three levels (8G = the most sensitive).
Camera Settings
-
Resolution
– VGA up to 12 megapixels.
- Quality – Fine, Normal and Economy.
- Exposure – Controls the brightness of the screen (the higher the number, the bright-
er the screen).
- Quick view – Once a photograph is taken, it will remain on the display for a few
seconds to allow the viewer a brief check.
- Date stamp – Photographs are marked with the time and date.
System Settings
-
Date/time
– The time and date can be altered by the Up/Down buttons. This can
then be set by pressing OK.
-
Auto power off
– When activated, the camera will switch off after 1 to 3 minutes
of inactivity.
-
Screen off
– When activated, the display will switch off after 3/5/10 minutes of ina-
ctivity. This also occurs when the camera is recording. Pressing any button will turn
the display back on.
- Key tone – Switch key tones on and off.
- Language – Select the language for the system and any notifications.
-
Frequency
– Set the frequency for videos (Europe is 50 Hz).
- Format – This will delete any data on the memory card.
- Factory settings – This will restore all factory settings on the camera.
- Firmware version – Shows the current firmware version.