Service Manual
Setup
Terminator Salvation™ Copyright © 2010 T Asset Acquisition Company, LLC
Page 6
Setup
Unpack Materials
1.
Place the shipping crates on a flat, stable surface.
2.
Cut the banding straps and remove the cardboard lids.
3.
Lift off the large cardboard containers surrounding the front pedestal and monitor assemblies
and remove any shipping cleats.
4.
Remove the coin door key from the coin return slot.
5.
Open the top coin door.
6.
Locate the keys for the back door and the cash box door.
7.
Open the cash box door and remove the cash box.
8.
Check for shipping damage to the following:
•
Left and right guns, cables and decals
•
Marquee and monitor
•
Cabinet decals
9.
Check the AC line cord for visible signs of damage.
Pay particular attention to the plug and line cord insulation.
Check Electrical Settings
1.
Verify the voltage in the nearest AC outlet.
2.
Verify the AC outlet ground connection is present and working.
3.
Open the back door of the monitor assembly.
4.
Near the AC power transformer, verify the voltage selector switch is set to correct AC voltage.
5.
Route the line cord so that the plug is near the AC outlet.
6.
Replace the back door of the monitor assembly.
Startup Game
1.
Plug in line cord to AC outlet.
2.
Turn the power switch to ON.
3.
Check that no component is excessively hot or emitting foul odors.
If not, turn off AC power and disconnect line cord. Refer to the diagnostic section of this manual.
4.
Once software loads, you will be asked to calibrate the guns.
If not, enter the service menu by pressing the TEST button located on the bracket inside the top
coin door.
To Purchase This Item, Visit BMI Gaming | www.bmigaming.com | (800) 746-2255 | +1.561.391.7200
