Service Manual
Maintenance
Terminator Salvation™ Copyright © 2010 T Asset Acquisition Company, LLC
Page 30
Gun Trigger Service
To replace the trigger spring, refer to the picture below for its placement in the gun housing.
1
Install the plastic trigger so it presses against the spring, and the bottom part of the trigger will
press the switch actuator when a player pulls the trigger.
2
To replace the micro switch, remove the two screws that secure the switch in place. Remove the
two wires and install them on the same terminals on the replacement switch.
3
Connect the signal wire to the NO connector (middle connector) and the black ground wire to
the C connector.
Trigger Mechanics and Wiring
Gun Button Service
These instructions explain service for components of the lighted buttons.
1
If you replace a button micro switch, connect the signal wire to the NO (middle) connector and
the black ground wire to the C connector. Failure to do so will cause the button to not work.
2
To replace the LED bulb, pull the lamp assembly straight out of the button housing, and then
pull the bulb straight out of the lamp housing. The two lamp wires are interchangeable and can
connect to either terminal on the lamp housing.
Gun Coil Assembly Service
The coil assembly provides the force-feedback recoil when the gun is fired. Perform the following steps
to replace components of the coil assembly:
1
Open the gun case as described earlier.
Fit nub on
trigger here.
NO to signal
wire
Com to gnd wire
switch actuator
trigger microswitch
Long end of trigger spring
goes behind actuator.
Trigger spring fits
over plastic nub.
Trigger presses against
short end of spring.
To Purchase This Item, Visit BMI Gaming | www.bmigaming.com | (800) 746-2255 | +1.561.391.7200
