Terminator Salvation™ 42” Fixed Gun Game
Page 29
Terminator Salvation™ Game Software Copyright © 2010 PlayMechanix ™ Inc. All rights reserved.
Opening the Gun Case
Open the gun case to service the trigger, buttons, and coil assembly. You do not need to open the case
to service the pots that aim the gun.
1
To open the gun case, first remove the 12 Torx security screws shown by the single arrows in the
picture below, and remove the corresponding nuts from the other side of the gun.
2
Remove the four screws shown by the double arrows in the picture below. These screw into the
frame, so there are no nuts to remove.
3
Carefully remove the left side cover from the gun, being careful not to pull the wires from the
grenade button on the cover. The wires are long enough that you can set the cover on the
control panel near the gun without disconnecting the wires.
Closing the Gun Case
1
To close the gun case, first align the slots that fit around the gun PCB (with the LED display), and
then carefully put the two halves together. Make sure no wires or components get caught or
pinched. Pay special attention to the area around the trigger and spring, the wires coming out of
the frame shaft, and the wires attached to the coil and barrel light.
2
Insert the four (4) 3/8" x 10-32 screws shown with the double arrows. Partially tighten all four
screws, verify the case is mating properly, and then tighten the screws snugly.
3
Check the trigger to make sure it works properly. The trigger or spring could shift while you are
assembling the case.
4
Replace the remaining 8-32 screws and nuts, shown by the single arrows above, and tighten
snugly. The screw at the top of the muzzle end is 3/4" long, and the two screws in the handle are
1" long, as shown above. All of the other screws are 1 ¼" long.
1”
1”
¾”
To Purchase This Item, Visit BMI Gaming | www.bmigaming.com | (800) 746-2255 | +1.561.391.7200
