AMS42-LAN16fx
Seite 11
These channels are accessible at the back of the amplifier measurement system and not at the 37-pin
D-Sub females of the device anymore (see chapter 3.5.2 and 3.6.1).
7 Important Notes for Using the AMS42-LAN16fx
•
The device is only suitable for extra-low voltages - please observe the relevant regulations! Only
use the device with housing closed. ESD voltages at open lines may cause malfunction.
•
Only use an electrical isolated power supply unit (with CE).
•
For cleaning only use non-solvent detergents. The product is designed to be maintenance-free.
•
For calibration purposes, the device must be returned to BMC Messsysteme GmbH.
•
For reasons relating to CE use shielded cables. Connect the shield to ground at one end only.
Close open inputs if possible. ESD voltages on lines may cause malfunction during operation.
•
When mounting the cassettes, a connection between power supply ground and chassis of the
device is made via the module screw.
•
The Gain is adjusted to even values. Therefore only 64000 (with 16 bit) values of the full range of
the converter are used. As a result, the measuring ranges are effectively slightly larger (e.g.
±
5.12V)
than the indicated measuring ranges, providing for the advantage that overranges can be recog-
nized.
•
The device must not be used for safety-relevant tasks. With the use of the product, the customer
becomes manufacturer by law and is therefore fully responsible for the proper installation and use
of the product. In the case of improper use and/or unauthorized interference, our warranty ceases
and any warranty claim is excluded.
Do not dispose of the product in the domestic waste or at any waste collection places. It has to be
either duly disposed according to the WEEE directive or can be returned to bmcm at your own
expense.
Via Paolo Uccello 4 - 20148 Milano
Tel +39 02 48 009 757 Fax +39 02 48 002 070 [email protected] www.dspmindustria.it
