BMB Technology Nova Pro, Инструкция по установке, эксплуатации и обслуживанию

Страница: 23 / 44

Page 20 of 44
Using push fit connections
Push In Collet
Pull Tubing
Step 1:
It is essential that the outside diameter of the tubing being
inserted into the fitting is completely free of scratch marks, dirt and
any other material. Inspect the outside of the tubing carefully.
Step 2:
It is also very important that the sliced edge of the tubing is
cut cleanly. If the tubing needs to be cut, use a sharp knife of
scissors. Make sure to remove all burrs or sharp edges before
inserting the tubing into the fi tting.
Step 3:
The fitting grips the tubing before it seals. Lightly push
the tubing into the fitting until the grip is felt.
Step 4:
Now push the tubing into the fitting harder until the tube
stop is felt. The collet has stainless steel teeth which hold the
tubing in position while the O-ring provides a permanent leak
proof seal.
Step 5:
Pull on the tubing away from the fi tting and make sure it
is stays fi rmly in place. It is good practice to test the connection
with pressurized water before fi nishing installation.
Step 6:
To disconnect the tubing from the fitting, ensure that the
system is depressurized first. Push in the collect squarely against
the face of the fitting. With the collet held in this position, the
tubing can be removed by pulling. The fitting and tubing can be
reused.