Copyright © 2009 Bluworld of Water, LLC. All rights reserved.
3.
Dirty filter (Water Wonders units, Trellis, Be
llezzas, Contempos, Watergardens, Piavascos and
Serrano Horizontal fountains do not have filters).
Remove re-usable filter from pump, clean and re-install.
4.
Pump is clogged or malfunctioning
Refer to pump cleaning instructions. If still not working, unplug the fountain contact customer
service.
WATER LEAKING BEHIND THE PANEL
1.
(Bluworld Fountains) Distribution bar is not fully inserted into the elbow
Turn off the water feature and carefully twist the distribution bar back and forth while applying light
pressure to ensure it is completely inserted into the elbow.
2.
(Bluworld Fountains) Distribution bar o-ring gasket is misaligned
Turn off the water feature and carefully twist the distribution bar back and forth and remove the
distribution bar. Located on the distribution bar is a thin o-ring gasket. Make sure the gasket is
properly aligned and reinsert the distribution bar into the elbow.
3.
(Water Wonders Fountains)Hose connection could be cut
Drain the fountain and remove it from the wall. Check the hose connection. Be sure the hose clamp
is tightened securely but not so tight that it has cut the hose. It the hose has been cut it will need to be
replaced.
4.
Water flow is too strong
Locate the water flow control valve between the pump and the inlet hose.
The flow valve on Water
Wonders fountains, Table Tops , Bellezzas, Piavascos and Water Ga rdens is a black disc located on
the top of the pump.
Turn the valve clockwise to slow the water flow.
5.
(Bluworld Water Fountains except Mini Moon shadow - WWMMC)Holes in the m anifold are facing
the wrong direction
Rotate the manifold distribution bar until the holes are facing in the correct direction. If the water is
aimed too high on the distribution plate, it could overflow onto the backside of the fountain.
RESERVOIR IS LEAKING
Too much water
Always maintain the water level at least 2” above the water pump but ½” below the hole where the
electrical cords run through. The pump should be completely submerged underwater and should be
checked every 3 – 4 days.
SPLASHING
1.
Pump is not completely submerged
The water level should be at least 2” above the pump. If the water level is too low, the pump will take
in air along with the water and will cause a spitting effect from the manifold.
2.
Flow valve is not set properly
Locate the water flow control valve between the pump and the inlet hose.
The flow valve on Water
Wonders fountains, Table Tops , Bellezzas, Piavascos and Water Ga rdens is a black disc located on
the top of the pump.
Turn the valve clockwise to slow the water flow, counter-clockwise to increase
it.