Bluezone PK-220, Инструкция по установке, эксплуатации и обслуживанию

Страница: 12 / 31

Document #: BPI-PM013-00
11
Ceiling Mounting:
Overview
The PK-220 is designed with the option
to be installed onto a 2’ X 4’ opening in the grid frame of
a standard suspended ceiling with 2’ X 2’ or 2 X 4’ tiles.
Only mount the PK-220 to a properly installed and structurally strong suspended ceiling with
structural members above the ceiling tiles to attach support wires.
NOTE:
It is the installer’s responsibility to:
●
Determine if the drop ceiling structure is capable of supporting an additional load of 50lbs.
●
Assure local building, electrical and safety codes are followed related to the installation of
this equipment.
● Provide electrical hookup cable as determined by an on-site electrician.
● Provide the 12-gauge hanger wire to support both the ceiling grid and the PK-220
Assembly and installation of the PK-220 is
a “two-person” job to avoid injury and potential
damage to the unit. The installer could consider a duct lift to raise the PK-220 unit into the
ceiling opening.
Clearances
The PK-220 is inserted into the ceiling opening at an angle and then seated into the ceiling grid
as shown in Figure 11 and Figure 12. Clearance of 1
8” above the ceiling grid is needed in order
to accommodate the insertion of the unit into the ceiling.
Clearance on the sides of the unit is 12”.
Installer may use judgement to decrease clearance to 0 on one or two sides of the unit if there is
additional head height to maneuver.