Bluewater Pro, Руководство пользователя

Страница: 9 / 172

09
© Bluewater Group 2017
EN
Installation
Pro must not supply water to all the faucets in the house. This can cause
corrosion in the water pipes and water heaters.
If Pro was not correctly installed, warranty will not cover it.
Installation must comply with applicable local plumbing codes and regulations.
Only connect the water purifier to the cold water supply. The water must be of
sufficient quality and fulfill the requirements on feed water.
We recommend that the water purifier is installed by a professional, who is recommended by
an authorized Bluewater dealer.
Installation instructions can be found in the Complete User manual and on
www.bluewatergroup.com.
Leak protection system
A sensor at the bottom of the water purifier senses water leaks. If there is a leak, the feed water supply is stopped. The water
purifier cannot be started again until the leak has been repaired.
Low pressure protection
If Pro stops because of low pressure, the cause of the low pressure must be
removed. If not, the pump can be permanently damaged.
When Pro has stopped because of a low pressure problem (feed water), water
production can be started manually by pushing the calibration button.
Low pressure restart function
Only included in models suitable for commercial use.
The low pressure restart is a function to ensure maximum availability of water.
Pro starts automatically when it has stopped because of low pressure. It tries to start three times: after 3 minutes, after 20
minutes and after 4 hours. If the water pressure is not sufficiently high after three tries, Pro will stop.