OPERATION
8
24” Battery Automatic Scrubber (04--06)
7. Raise brush head. To raise brush head, step
down firmly on the bottom brush lift foot pedal until
brush locks into the raised position (Figure 7).
FIG. 7
FILLING SOLUTION TANK
1. Drive machine to fill station. Raise squeegee and
brush when transporting.
2. Shut off solution flow, pull back completely on
solution flow lever (Figure 8).
FIG. 8
FOR SAFETY: Before leaving or servicing
machine, stop on level surface and turn off
machine.
3. Remove fill-port cover at front of machine and fill
solution tank with 10 gallons (37.8L) of clean
water, 60
°
C (140
°
F) maximum temperature. Or
use the rear fill port to fill solution tank. Pull off
plug and insert hose to fill. The clear tube below
the fill port has 5 and 10 gallon markers to indicate
amount of water in tank (Figure 9).
NOTE:
The water must
not
be hotter than 60
_
C
(140
_
F) or tank damage may occur.
FIG. 9
NOTE:
If filling with a bucket be certain that bucket is
clean. This will prevent possible solution line clogs.
4. Add cleaning chemical. See proper dilution ratio
instructions on bottle.
FOR SAFETY: When using machine, follow mixing
and handling instructions on chemical containers.
ATTENTION: Use only recommended detergents.
Machine damage due to improper detergent usage
will void the manufacturer’s warranty. Contact
your Sales Representative for detergent
recommendations.
WARNING: Fire or Explosion Hazard.
Never Use Flammable Liquids.
