OPERATION
24” Battery Automatic Scrubber (06--04)
11
DRAINING TANKS
The recovery tank should be drained and cleaned out
after every use. The solution tank should be cleaned
out periodically to remove any corrosion.
Transport the machine to a draining site, turn the
machine off and follow the draining instructions below:
FOR SAFETY: Before leaving or servicing
machine, stop on level surface and turn off
machine.
DRAINING RECOVERY TANK
1. Remove drain hose from holder, position hose
over floor drain and twist off drain hose plug. To
completely drain recovery tank, hinge open tank
sideways and flip up tank support stand to rest
tank on (Figure 17).
FIG. 17
NOTE:
When using a bucket to drain the machine, do
not use the same bucket to fill the solution tank.
2. Rinse recovery tank after each use. This will
prevent a foul odor. Unscrew clear lid on recovery
tank. Use a hose to rinse out the recovery tank.
Be careful not to spray water into float shut-off.
3. Replace drain hose plug tightly when tank is
empty.
DRAINING SOLUTION TANK
1. Pull clear gallon marker hose off hose barb at rear
of machine and drain solution into floor drain or
bucket (Figure 18).
FIG. 18
2. Flush solution tank with clean water after each
use. This will prevent clogging due to chemical
buildup. Let clean water drain out through clear
hose.
3. Push solution flow lever forward to rinse out
solution flow system.
4. Reconnect clear hose to hose barb. Be certain
hose is completely pushed onto hose barb.
CHARGING BATTERIES
ATTENTION: To prolong the life of the batteries
and to provide optimum machine performance,
ONLY recharge the batteries after a total of 30
minutes of use or more. Do not leave batteries
discharged for lengthy periods.
The following charging instructions are intended for
battery chargers supplied with the machine. Only use
a battery charger with the following specifications to
prevent battery damage.
BATTERY CHARGER SPECIFICATIONS:
S
OUTPUT VOLTAGE - 24 VOLTS
S
OUTPUT CURRENT - 10 TO 20 AMPS
S
AUTOMATIC SHUT OFF CIRCUIT
S
FOR DEEP CYCLE BATTERY CHARGING
1. Transport the machine to a well--ventilated area
for charging.
WARNING: Fire Or Explosion Hazard.
Batteries Emit Hydrogen Gas. Keep Sparks And
Open Flame Away. Keep Battery Compartment
Open When Charging.
