C G - 2 1 1 Y T O R C H B U R N E R M A C H I N E
9
•
12= Constant
•
Example: d=299mm=29.9cm=30 sections of chain.
o
D=30+12=42 Sections of Chain Total, So you would use 42
sections of chain for a pipe 299mm in diameter.
Ø
Tighten up the main chain tightening wing-nut until the machine is adequately tight.
o
Do not over-tighten wing-nut.
o
Ensure the chain is at a straight 90 degree to the pipe.
Ø
Engage the clutch handle on the clutch carriage assembly. This should engage the worm-wheel
and allow for activated movement when the handle is turned.
o
Turn the handle to ensure movement
Ø
Select appropriate size torch tips for the application. Install tip.
Ø
Select cutting angle.
Ø
Connect applicable gas lines.
o
Make certain they are properly secured and there are no leaks. It is highly recommended
that leak testing be performed on the system prior to using the machine.
o
Ensure the lines are long enough to complete the cut you are planning.
o
ALWAYS use gas tank cylinders with properly outfitted regulators/flowmeters.
Ø
Ensure the torch holder is not too close to the side of the machine body.
Ø
Adjust the side knobs to raise the torch tip to a suitable level for lighting.
Ø
Light the torch flame (see section below on proper lighting of torch flame).
Ø
Adjust the side knobs a suitable level for cutting though the material.
Ø
Cut material by rotating the worm-wheel handle.
o
CAUTION: Make certain the user is clear of the flame when manually rotating the handle.
Ø
When the cut is complete, stop the machine rotation.
Ø
Shut off the torch flame.