1 2 ” Z 1 L R B / T S C O R E D R I L L
12
o
Make certain the spindle is facing the ground so as not to get oil/grease
everywhere. Locate the hex screws holding the gear housing together and
remove them.
o
Gently pull the gear housing apart. You may use a couple flat screwdrivers to
gently apply pressure to separate the housings.
o
Take the main clutch nut off of the clutch. Apply some Loctite type of thread
glue on the clutch threads.
o
Reapply the nut to the thread.
o
Hold the spindle in place using the box wrench. See diagram below.
o
Use the torque wrench to tighten the clutch nut.
o
Torque the tensioning nut to 40 NM (354 inch/lbs, 29.5 ft/lbs).
o
With the clutch nut tightened, reassemble the housings. Make sure the
orientation of the internal gears is correct and the housings mate correctly.
o
Reattach the bolts that hold the housing together.
