1 2 ” Z 1 L R B / T S C O R E D R I L L
7
Ø
This machine has one primary adjusting point for the angle between the drill stand and the drill motor. The
angle Adjusting bolt (12 below) can be loosened to adjust the angle and retightened when desired angle is
achieved. NOTE: The drill carriage can also be locked in place by twisting until the locking bolt engages
towards the carriage. To unlock the carriage pull out the bolt and turn.
TRANSPORTING THE MACHINE
Ø
When transporting the machine, always lock the carriage bolt.
Ø
Always carry the machine with both hands.
Ø
DO NOT transport the machine with bits in the spindle.
Ø
When using the wheels, tilt the machine back towards the operator and once the wheels are engaged with
the ground pull or push the machine on the ground.
o
Avoid dragging the vacuum rubber. You can take the rubber out if not using.
Ø
If transporting inside a vehicle, it is recommended to transport it on its side so as to avoid the item falling
over.
Ø
DO NOT carry/pull the machine by the cord.
Ø
DO NOT allow the cord or plug to drag along the floor when transporting.
1) Motor Brush Holder
2) Motor On/Off Switch
3) Top Bolt for Binding in Ceilings
4) Drill Motor
5) Carriage Adjusting Bolts
6) Water Hose and Valve
7) Drill Carriage
8) Feed Handle
9) Gearbox
10) Spindle
11) Drill Stand
12) Angle Adjusting Bolt
13) Stand Base
14) Base Wheels
15) Leveling Bolts
