TOOLS NOT MAINTAINED PROPERLY CAN CAUSE SERIOUS INJURIES TO
TOOL OPERATORS AND BYSTANDERS. CLEAN TOOLS AT LEAST ONCE A
WEEK OR AFTER 1000 SHOTS.
Always ensure that the tool is unloaded and use safety goggles before
performing any service or repair.
COMPLETE CLEANING / GENERAL MAINTENANCE
Heavy or constant exposure to dirt and debris may require that the tool be
cleaned more extensively. Complete disassembly and cleaning of all parts
may be necessary to restore the tool to normal operation. General
maintenance should be performed every week or more often if the tool is
subjected to heavy use.
ALWAYS FUNCTION TEST THE TOOL AFTER PERFORMING ANY SERVICE.
CARE AND MAINTENANCE
Care of the tool
The outer casing of the tool is manufactured from impact resistant
plastic. The grip comprises a synthetic rubber section. The ventilation slots
must be unobstructed and kept clean at all times. Do not permit foreign
objects to enter the interior of the tool. Use a slightly damp cloth to clean
the outside of the tool at regular intervals. Do not use a spray or steam-
cleaning system for cleaning.
Maintenance
Check all external parts of the tool for damage at regular intervals and check
that all controls operate properly. Do not operate the tool when parts are
damaged or when the controls do not operate properly. When necessary,
have the tool repaired by an authorized repair center.
WARNING!
•
The tool gets hot when
in use.
•
DO NOT disassemble
the tool when it is hot.
Servicing the tool
The tool should be serviced when
any of the following occur:
1. Cartridges misfire.
2. Fastener driving power is
inconsistent.
3. You notice that:
contact pressure increases, trigger
force increases, power regulation is
difficult to adjust (stiff), the
cartridge strip is difficult to remove.
MAINTENANCE
15
OPERATING INSTRUCTIONS
1.
After checking to make sure that the
tool is not loaded, point it in a safe
direction and make sure the barrel is
fully extended and close the tool to
the semi-closed position. This
ensures that the piston is in position
for the next fastening operation.
NEVER LOAD A FASTENER
WITH YOUR FINGERS ON
THE TRIGGER
OPERATING THE BP-303A TOOL
DO NOT USE EXCESSIVE
FORCE WHILE INSERTING A
FASTENER
2.
With your finger off the trigger,
place the fastener, point out, into
the end of the fastener guide until
the end is inside the fastener guide
completely. STOP immediately if
excessive force is required; inspect
the barrel to find out why the
fastener is not entering the fastener
guide easily. Do not continue to use
the tool unless the problem is
corrected. DO NOT use excessive
force when inserting a fastener.
NEVER load a fastener with your
finger on the trigger.
3.
With the tool pointed in a safe
direction and your finger off the
trigger, insert the strip in the tool
through the bottom of the handle.
Make sure the load is inserted
correctly.
4.
After shooting pull the fastener
guide out on the tool and push it
back in, this will allow the strip to
advance.
14
Содержание BP-303A
Страница 12: ...23 NOTES 22 NOTES...
