Page 19
www.bluenetvideo.com
BlueNet Video
888-616-1514
After correctly forwarding the Web Server Port and the Video Server Port through your router (if
applicable), you may then install the NVS in a proper location.
1. Locate the serial number located on the label attached to the bottom of the NVS, you will need this
for DDNS registration.
2. Connect a device to the NVS (camera, DVR, Pan/Tilt/Zoom, etc.) and supply power to the device
3. Connect the NVS to your router or cable/DSL modem (per your network scenario) via a Cat5/5e
UTP Ethernet network cable.
4. Supply power to the NVS
5. After 30 seconds, verify the NVS indicators:
POWER:
Solid
ACTIVE:
Flashing
100M:
OFF
10M:
Flickering/Solid
6. After configuring Port Forwarding on your router (if necessary), you may then access your NVS on
your local network by opening Internet Explorer and specifying the IP address and Web Server Port
that you have assigned to the NVS.
Examples: http://192.168.0.200:8888 or http://24.106.88.123
*** if you left your Web Server Port set to 80, then you don’t need to specify the port in the
Address Bar when accessing the NVS
