3
SAFETY MAXLED 85 W
• Only suitable for indoor use.
• Ensure voltage shown on the label match to the mains supply voltage.
• Never look directly at the LEDs! UV and Infrared (IR) emitted from this light may cause permanent
eye and/or skin damage, always minimize exposure to eyes and skin, the supplier is never
responsible for any wrong usage of this light.
• A drip loop must be used with all electrical aquarium devices to prevent water leakage into the
power socket (see image).
• Although the LED lamp is splash waterproof it should not be submerged in water and there should
be at least 15 mm between water level and lamp. Attach the lamp firmly.
• Only plug light into mains after the LED lamp is firmly mounted above the aquarium.
• Always dry your hands before doing any jobs on the LED lamp or operating the lamp switch.
• Always disconnect electrical supply before you perform any maintenance on aquarium and LED
lighting.
• The LED unit can get warm, allow adequate time to cool down attempting any maintenance.
• Make sure cable and light are undamaged before usage, If damaged the supply cord cannot be
replaced, the whole unit needs to be recycled. Never shorten or lengthen the electrical leads.
• If overpowered, the adapter can be replaced, buy a replacement adapter from your dealer.
• In the unlucky event that the LED unit falls into the water, first unplug it and then retrieve it by
using the cable to lift the unit out of the water.
• Warranty is not valid when the unit is damaged due to submersing.
INSTALLATION
;
Required tools, small flathead Screwdriver included.
Step 1: Attach the flexible bracket to the bracket support, using the 4 short bracket bolts and tighten
these down with the screwdriver.
Step 2: Attach flexible bracket to LED unit by pushing the legs into the unit.
Step 3: Place bracket support on the aquarium tank, adjust legs, with supplied screws of different
length, depending on the glass thickness choose the correct screw and tighten the bracket onto
the glass tank.
Step 4: Connect remote control to power cable, tighten the connection to make it waterproof, connect
ballast and powerplug.
Step 5: Optional hanging bracket installation, a hanging bracket is available as an accessory at your
Blue Marine dealer.
PROTECTION FUNCTION:
• The smart fan will start when the temperature of the light is above 40°C and stop to work below
40°C. The light will automatically turn off when its temperature is around 70°C.
MAINTENANCE:
1. Regular cleaning with a moist cloth will improve life time and light output.
2. The LED lamp have a minimum life time of 30.000 burning hours.
3. The LED lamps cannot be replaced, once the LED lamps stop burning the whole unit needs
to be replaced.
MaxLed 85
GB
