Setup
When installing the equipment, please make sure that cables are installed so that accidents cannot
occur.
Cables connected to the equipment must not be subject to any mechanical strain.
Step 1: Connect Network
Eight1080, Nine1080 and Six4K:
Connect Ethernet cable to LAN1 (Top LAN Port) on appliance and connect to video source
network switch.
LAN1 is the primary network port, LAN1 should be used for video streaming interfaces.
LAN2 is the secondary network port.
Step 2: Connect Monitors/Display Devices
Eight1080, Nine1080 and Six4K:
Connect required graphics outputs, starting from left to right looking at the rear of the unit
to the monitor(s). Looking at the rear panel the Outputs run from left to right, 1 to N. Connect
graphics outputs using DisplayPort cables or active DP to HDMI adapters for HDMI cables.
If you encounter any issues with displays try the following:
●
Power Cycle Monitor
●
Try Disconnecting and Reconnecting cable
●
Restart System
●
Try Shorter Cable
IMPORTANT: When connecting appliance to monitors via DisplayPort (Not using DP to HDMI
adapters), to avoid any issues with displays, it is highly recommended to disable any
"Power-Saving" features your monitors have via the monitor settings menu.
Video Wall Controller Series User Manual
Page
15
Copyright © 2020
