A
Appendix A: Gas Type Conversion
36
© Moffat Ltd, January 2007
Revision 1/
Blue Seal Evolution Series Gas Griddles
8.
Refit the front control panel and tighten the 2 screws on the underside to secure the panel in place.
9.
Refit the control knobs to the front control panel. The control knobs are a push fit onto the shafts of
the gas control valves.
Low Fire Adjustment - (Gas Griddle)
To change the gas griddle thermostat ‘Low Fire’ adjustment, the low fire screw on the gas control valve
should be screwed fully in, then unscrewed by 1 full turn as shown in the “Gas Specifications” table at the
end of this section.
1.
Remove the griddle gas control knob from the
front control panel. The knob is a push fit
onto the shaft of the gas control valve.
2.
Remove the gas griddle control panel from the
front of the gas griddle by removing the 2
securing screws in the lower corners of the
panel.
3.
Screw the ‘Low Fire’ screw fully ‘IN’ and then
unscrew by 1 Full Turn of the ‘Low Fire’
screw. (Refer to the ‘Gas Specification’ table
at the rear of this section).
4.
Refit the control panel and secure with the
securing screws.
5.
Refit the gas control knob to the shaft of the gas control valve.
NOTE: The “Low Fire Screw” should be sealed with coloured paint on completion of the low fire
adjustment.
Low Fire
Adjustment Screw
Fig A4