Blue Seal Fast-Fri E43, Инструкция по установке и эксплуатации

Страница: 18 / 39

16
Operation
Before Use
1. Check that the main power supply is turned on.
2. Check that there are no foreign articles in the tank(s).
Filling the Tank(s)
NOTE: BLUE SEAL 'Deep Fryers’ can be used with both oil and shortening.
1. Before filling the tank, always check that the drain valve(s) behind the access door is (are) closed. A
locking slide is provided on these valves and this should always be locked in position during use.
2. Ensure that the elements are swung down into the tank(s).
a. OIL - Carefully fill fryer tank with oil until the 'FILL-LEVEL' mark is reached. Carefully pour the
cold oil into the fryer tank(s) until the tank is filled to the 'LO' level marked on the tank side.
Pre heat the oil to 120°C, the oil will expand as heated until it reaches the 'N' level when warm
(100-120°C) and will reach the "HI" level when the oil is hot (180-190°C). Set the thermostat to
the required operating temperature.
• The E43 single tank fryer will hold 27 to 29 litres of oil (22 - 23kg of shortening).
• The E44 twin tank fryer will hold 14 litres of oil per pan (11kg of shortening per tank).
b. SHORTENING - Ideally shortening should be pre-melted prior to putting it into the tank. This is
normally done in a suitable vessel on a boiling table burner(s). The liquefied shortening can then
be poured into the tank until it reaches the 'FILL LEVEL' mark.
Pre-Heating
NOTE: When pre-melting shortening, only heat the shortening until it is just liquefied. Do not bring
the shortening up to high temperature as handling of hot shortening is dangerous.
• If pre-melting of shortening is not possible, carefully cut the shortening into small pieces and
pack below, all around and above the elements, ensuring that the element can fully lower to
operate the element tilt microswitch otherwise the fryer will not operate.
E43 and E44;- Set the tank control thermostat to 120°C and switch ‘ON’ the appliance for 30
seconds and then ‘OFF’ for 1 minute. Repeat the cycle until all the shortening is melted
enough to apply full power to the heating elements. To speed up this process, break up the
shortening and stir carefully during the melting process.
NOTE: Running the elements continuously will cause the shortening in contact with the tank to
overheat, resulting in premature oil breakdown. Never allow the shortening to smoke while
melting as this indicates that the temperature is too high. If the shortening starts smoking,
increase the ‘Off’ intervals of the elements.
WARNING:
D
ANGER OF FIRE EXISTS IF THE OIL LEVEL IS BELOW THE MINIMUM
'LO'
INDICATED LEVEL
Fig 3
CORRECT LEVEL FOR FRYING MEDIUM WHEN
AT FRYING TEMPERATURE, KEEP TOPPED UP
INDICATES CORRECT FRYING MEDIUM LEVEL
WHEN COLD