-30-
Revision 3/F3601
6.5.8 DOOR BALL CATCH SETTING
A
C
B
E
D
Figure 6.5.11
10) Replace Torx head screw and release
knob.
11) Test oven temperature, and re-adjust if
required.
12) Push snap cap back into position on knob.
1) Open right hand oven door.
2) Loosen the door catch locknut.
3) Turn the slot on the ball catch to adjust the
height of the roller, anticlockwise to
increase height, clockwise to decrease
roller height.
4) Tighten locknut.
Figure 6.5.12
Ball
catch
6.5.9 DOOR ALIGNMENT
A small amount of adjustment can be made to
the alignment of the oven doors in order to
ensure a good seal.
1) Open the oven doors, and loosen the
screws securing the door hinges to the
oven.
2) Adjust the door position a small amount to
ensure even sealing around the perimeter
of the door. As a guide, a single sheet of
paper should be able to be inserted
between the metal to metal seal.
3) Tighten the screws, and recheck the door
position.
5) The position of the door catch plate can
also be adjusted in or out to ensure that
the door closes correctly.
Figure 6.5.13
Ball
catch