Remote Control
How to Program your Remote Control to your Television:
1.
Have DTA within sight of the remote control during programming
2.
Find the manufacturer’s code for the customer’s TV brand
3.
Turn on your TV and DTA Mini Box
4.
On your remote, press and hold the Setup button until the LED indicator changes from red to green on
the remote control. While the light stays green, have the customer enter the 5 digit code and watch
for the light to blink green twice after entering the code.
5.
Press the TV Power button immediately on the remote control. If the TV turns off, you know the code
has been accepted. Turn the TV back on and make sure that the VOL+/- and Mute buttons also work.
If so, programming is complete.
6.
If not, repeat these steps with each of the manufacturer’s codes that were found. If you still can’t find
a code that works, try the ‘Search Method’ listed.
If Remote Programming is unsuccessful, attempt to Reset TV Programming, then proceed
with the steps listed above to Program your Remote Control to your Television:
(Resets only TV programming)
1.
Press and hold the Setup button for three seconds until the LED Indicator turns green on the remote
control
2.
Enter 9-8-6 on the remote control
3.
The LED Indicator will blink green twice on the remote control
Remote Programming – Search Method:
1.
Turn on your TV
2.
On your remote, press and hold the Setup button until the LED indicator changes from red to green on
the remote control
3.
While the light stays green, Press the Yellow A button
4.
Press the Channel ^ button multiple times until the TV turns off
5.
After the TV turns off, press Setup
6.
Successful TV IR code storage is indicated by 2 green blinks on the remote control
Note:
If you press the Channel ^ button again after the TV turns off, you will not be able to go back to that
code. You will need to begin the programming method from the beginning again.
How to Pair a Remote Control to a DTA (RF):
1.
Ensure that you have line of sight of the DTA Mini Box during the pairing process
2.
Press the Menu button
