Blue Diamond® Attachments
6
3. Operation
3.1
General Information
The following precautions must be observed for
the safety of the operator and bystanders.
Setup
Although the broom attachment is supplied
fully assembled, some simple checks should be
performed before operation begins.
Safety Decals
The safety decals existing on the attachment
should be clearly readable and always followed.
The location and description of the decals is
shown in the parts diagram. Copies of the decals
are shown in Safety Decals section.
Hydraulic Couplers
The broom may have been shipped without the
required hydraulic quick couplers. Obtain correct
brand and size and install them on the hoses.
Hoses / Fittings
Hydraulic fittings are used to connect all
attachment hoses. All fittings should be tight
and free of leaks. Hoses must be free of crimps
or cuts that might result in leakage. Check your
attachment before operation to make sure all hose
routings are kink-free and allow for movement
during sweeping and dumping operations.
Wire Harness
The wiring harness to the optional water spray
kit pump should be routed to prevent catching or
pinching when sweeping or dumping operations.
Attaching to Loader
Never crawl under raised loader arms or
attachment.
To attach the Broom to the loader:
1. Start the loader engine and rotate the coupler
out. Retract the coupler pins.
2. Move the machine forward and align the
coupler between the outer mounting bracket
plates. Pick up the attachment with the top bar.
3. Rotate the attachment back and engage
the coupler pins. Ensure coupler pins are
completely down and engaged. Always refer to
operating instructions in the skid steer manual.
4. Engage loader parking brake and stop the
engine. Cycle the controls to remove pressure
in the auxiliary hydraulic lines. Exit machine.
5. Clean quick couplers if dirty. Connect hydraulic
hoses are to the skid steer quick couplers.
6. While attachment is on the ground, visually
inspect quick coupler to ensure pins are
extended.
7. Connect the wiring harness.
Safe Broom Operation
• Always follow the safety and operating
information in this manual.
• Only operate the attachment from the seat of
the loader.
• Always follow the weight limitations of the
loader.
• Do not remove guards and shields.
• Do not sweep near or toward people, vehicles
or buildings that may be injured or damaged
by flying debris.
• Wear Eye protection around the attachment.
• Carry the attachment low to the ground.
• Do not carry passengers.
WARNING
WARNING
