2014-07
1 866 907 0122 blubathworks.com
2
Attaching the in-wall box for controller
• Prepare the wall to take the in-wall box. The installation of the in-wall box will depend on each individual
situation i.e. if there is access from behind the shower/tub/basin.
• A 14/7" (40mm) diameter hole is required if fitting the box from
‘behind’
and a 2 2/3" (68mm) diameter hole
if fitting from the
‘front’
.
• Conduits should be used in the walls where necessary to protect the cables and allow maintenance.
• Attach the in-wall box using the screws supplied.
In-wall box attached from ‘behind’
In-wall box attached from ‘front’
NOTE:
For PT7003 & PT7005, the control wheels can be installed either vertically or horizontally.
In case of vertical layout, the in-wall box must be positioned so that the openings at the
back are horizontal as shown in Fig.1.
1
Note:
The diagrams in this install indicate single wheel for basin installation (PT7001).
For dual wheel installation (PT7003/PT7005) duplicate these steps.
