Bloomfield 8783D3FM, Руководство пользователя

Страница: 7 / 24

915 2M-Z15131 Owners Manual for 8783MCD
INSTALLATION (continued)
5
NOTE: This equipment must
be installed to comply with all
applicable plumbing codes and
ordinances.
WARNING:
SHOCk HAzARD
Brewer must be properly
grounded to prevent possible
shock hazard. DO NOT
assume a plumbing line
will provide such a ground.
Electrical shock will cause death
or serious injury.
IMPORTANT:
Supply power must match
nameplate for voltage and
phase. Connecting to the
wrong voltage will damage the
brewer or result in decreased
performance. Such damage is
not covered by warranty.
IMPORTANT: Do not connect
brewer to electrical power until
you are ready to fill the tanks.
See instructions on page 6.
IMPORTANT: This brewer
requires a dedicated 20 amp
single phase 220 to 240 volt
AC circuit. Contact a licensed
electrician to install the proper
circuit.
NSF requires that the brewer be able to be moved for cleaning
underneath. Provided flex line will satisfy this requirement. See
Figure 2 below.
ELECTRICIAN’S INSTALLATION INSTRUCTIONS
IMPORTANT:
Do not energize this brewer until both water tanks are filled.
See filling instructions, page 6
REFER TO ELECTRICAL SPECIFICATIONS - Page 1
Check the nameplate to determine correct electrical service
required for the brewer to be installed.
IMPORTANT: Before connecting to electricity, make sure
automatic brewers are connected to the water supply.
Model 8783D3FM requires a dedicated 220 to 240 volt 20 amp
circuit (L1, L2) plus ground.
Wiring by others must be installed to the terminal block in Model
8783MCD. Wiring must be secured to the brewer with a strain
relief (by others). See Figure 3a below.
Fig. 3 Wiring Connections
Fig. 2 Water Supply Installation
IL2325
L1
L2
EAR
TH
GREEN
RED
BLACK