Bloomfield 4543-D2, Руководство пользователя

Страница: 5 / 16

INSTALLATION INSTRUCTIONS
READ THIS CAREFULLY BEFORE STARTING THE INSTALLATION
LEVELING THE UNIT
Place unit on a firm level surface.
A spirit level should be placed on the top of the unit, at the edge,
to be sure it is level.
ELECTRICIAN’S INSTALLATION INSTRUCTIONS
All models
are equipped with a cord and plug. They require a
115 - 125 volt 15 amp circuit (50/60 Hz, 2 wire plus ground, with
NEMA 5-15R).
IMPORTANT:
The ground prong of the plug is part of a system
designed to protect you from electrical shock in the event of
internal damage. Never cut off the ground prong nor twist a
blade to fit an existing receptacle. Contact a licensed electrician
to install the proper circuit and receptacle.
IMPORTANT:
To enable the installer to make
a quality installation and to
minimize installation time, the
following suggestions and tests
should be done before the
actual unit installation is started:
CAUTION:
EQUIPMENT DAMAGE
DO NOT plug in or energize this
appliance until all Installation
Instructions are read and
followed. Plug into the voltage
that is on the nameplate,
damage to the Brewer will occur
if these instructions are not
followed.
CAUTION:
UNSTABLE
EQUIPMENT HAZARD
It is very important for safety
and for proper operation that the
brewer is level and stable when
standing in its final operating
position. Provided non-skid
legs must be installed at each
corner of the unit. Failure to
do so will result in movement
of the brewer which can cause
personal Injury and/or damage
to brewer.
NOTE:
This equipment must
be installed to comply with
applicable federal, state and
local plumbing codes and
ordinances.
WARNING:
SHOCK HAZARD
Brewer must be properly
grounded to prevent possible
shock hazard. Electrical shock
will cause death or serious
injury.
4
WARNING
2M-Z16993-631 ECO Style Brewers