STEP 5 - Check SNR
STEP 6 - Configure QAM Output
STEP 7 - Set Output Mode
Go to the “Status” page:
>22 dB SNR for 8VSB; >33 dB for
QAM 256 is recommended.
(Increase the RF input level
as required to achieve the
desired SNR).
Go to the “Status” page:
Select number of IP outputs
(from 1 to 8) or “disabled”.
Click “Save”.
Go to the “QAM” page to setup the output channels:
Select the 1st channel for
each set of QAM outputs.
Ensure all “Output Control”
selections are set to “On”.
Ensure “CW Control” mode
is not selected/enabled.
Select the QAM modulation
under “Output QAM
Mode”.
Click “Save”.
1
1
2
1
2
3
4
5
1
1
3
4
5
2
1
2
