![background image](http://html1.mh-extra.com/html/blomberg/knm4551i/knm4551i_operating-instructions-manual_2774015011.webp)
EN
9
Installation Instructions
1.
The space in the room where the
appliance is installed must not be
smaller than 10 cubic metres.
2.
See for detailed Installation
Instructions including reversing door
opening direction.
3.
This appliance has been designed
to operate in ambient temperatures
up to 32 degrees C (90 degrees
F) and is equipped with Advanced
Electronic Temperature Control
System [AETCS] which ensures that
at the advised setting [4 - four on the
knob] the frozen food in the freezer
will not defrost even if the ambient
temperature falls as low as -15 °C.
When first installed the product
MUST NOT be placed in low ambient
temperatures because the freezer will
not reduce to it’s standard operating
temperature. Once it has reached
its steady operating state it can be
re-located. So you may then install
your appliance in a garage or an
unheated room without having to
worry about frozen food in the freezer
being spoilt. However at low ambient
temperatures mentioned above,
fridge contents are likely to freeze,
so check and consume food in the
fridge accordingly. When the ambient
temperature returns to normal,
you may change the knob setting
to suit your needs.If the ambient
temperature is below 0°C, the food
in the fridge compartment will freeze.
So, we recommend you don’t use
the fridge compartment in such low
ambient conditions. You can continue
using the freezer compartment as
usual.
4.
Do not place the appliance near
cookers, radiators or in direct sunlight
as this will cause your appliance to
work harder. If installed next to a
source of heat or freezer, maintain the
following minimum side clearances:
From Cookers 50 mm (2”)
From Radiators 300 mm (12”)
From Freezers 25 mm (1”)
5.
Refer to cleaning and care section
to prepare your appliance for use.
A special receptacle is supplied to
store the mains plug during transit.
The receptacle is fixed at the back
of the cabinet, on the side of the
compressor. (See diagram) Gently
remove the plug from the receptacle.
Never pull the mains cord, you may
damage the appliance. In the case
of transportation, ensure you locate
the plug in the receptacle provided to
avoid transit damage.