EN
7
3
Installation
B
Please remember that the
manufacturer shall not be held liable if
the information given in the instruction
manual is not observed.
Points to be considered
when re-transporting your
refrigerator
1.
Your refrigerator must be
emptied and cleaned prior to any
transportation.
2.
Shelves, accessories, crisper and etc.
in your refrigerator must be fastened
securely by adhesive tape against any
jolt before repackaging.
Please do not forget…
Every recycled material is an
indispensable source for the nature and
for our national resources.
If you wish to contribute to recycling the
packaging materials, you can get further
information from the environmental
bodies or local authorities.
Before operating your
refrigerator
Before starting to use your refrigerator
check the following:
1.
Is the interior of the refrigerator dry
and can the air circulate freely in the
rear of it?
2.
Please install the 2 plastic wedges
as illustrated in the figure. Plastic
wedges will provide the required
distance between your refrigerator
and the wall in order to allow the air
circulation. (The illustrated figure is
only an example and does not match
exactly with your product.)
3.
Clean the interior of the refrigerator as
recommended in the “Maintenance
and cleaning” section.
4.
Plug the refrigerator into the wall
outlet. When the fridge door is open,
the fridge compartment interior light
will come on.
5.
You will hear a noise as the
compressor starts up. The liquid and
gases sealed within the refrigeration
system may also give rise to noise,
even if the compressor is not running
and this is quite normal.
6.
Front edges of the refrigerator may
feel warm. This is normal. These
areas are designed to be warm to
avoid condensation.
Electric connection
Connect your product to a grounded
socket which is being protected by a
fuse with the appropriate capacity.
Important:
•
The connection must be in
compliance with national regulations.
•
The power cable plug must be easily
accessible after installation.
•
The specified voltage must be equal
to your mains voltage.
•
Extension cables and multiway plugs
must not be used for connection.
B
A damaged power cable must be
replaced by a qualified electrician.
B
Product must not be operated before
it is repaired! There is danger of
electric shock!
WARNING: Do not locate extension
sockets or charging transformers/power
supplies or Lithium-Iron battery operated
products adjacent to the compressor as
they could overheat.
3.
Packaging must be adequate
a
rt
f
o
s
e
l
u
r
e
h
t
d
n
a
nsportation
printed on the package must
be followed.
