Block V 120, Инструкция по эксплуатации

Страница: 19 / 23

REAR PANEL CONNECTIONS
P18
B
A
A
B
Main In
Main In
1. POWER SWITCH: Switches mains power on/off to internal
components, however please note that mains power is still
applied to this unit even though this switch may be off.
2. FUSE HOLDER: fitted with 20mm T 3A fuse inside.
" IMPORTANT:"
Remove the mains plug from the mains socket before attempting
to check/ replace the fuse located on this fuse holder.
3. MAINS CABLE INLET JACK: Please ensure that the input cable strain
relief bush is intact and has not been damaged.
4. WARNING ICONS: Please be aware that this unit contains high voltages,
and should not be opened, please refer to page 2 of this manual
5. LOUDSPEAKER A OUTPUTS . Please ensure that +/- connections are
made properly between rear of the amplifier and loudspeakers. Ensure
wires are not frayed or touching..
LOUDSPEAKER B OUTPUTS . Please ensure that +/- connections are
made properly between rear of the amplifier and loudspeakers. Ensure
wires are not frayed or touching.
6/7. Pre-AMP signal out put and Main AMP input.
Connected by a bridge.
8. AUX input jack.
9. TUNER input jack.
10. CD input jack.
11. PHONO input jack.
12. PHONO TERMINAL EARTH POST. It is necessary to provide a chassis
earth connection between the turntable and the amplifier. Failure to do
this will result in a buzzing or humming noise from the loudspeakers.
13. PHONE MM/MC switch