Blizzard POWER PLOW 810-1, Инструкция по установке и руководство пользователя

Страница: 11 / 52

Lit. No. 68251, Rev. 09 11 May 1, 2021
TORQUE SPECIFICATIONS
37° JIC Flare Torque Values
Turns Size
ft-lb
min–max
Assembly Steps
N/A -02 6–7
1. Make sure that the tubing and threads are clean.
2. Lubricate the threads with 10W hydraulic
fl uid.
3. Hand tighten the nut/sleeve to approximately 30 in-lb.
4. Make alignment marks on the nut and
fi tting.
5. Tighten to turn or torque speci fi cation.
6. When fully tightened, make a second set of alignment marks at the fully tightened position.
NOTE: Torque values speci fi ed are for threads lubricated with 10W hydraulic fl uid.
Overtightening will reduce the clamping force resulting in loss of seal and reduction of fl ow.
N/A -03 8–9
2 -04 11–12
2 -05 14–15
1-1/2 -06 18–20
1-1/2 -09 36–39
1-1/2 -10 57–63
1-1/4 -12 79–88
1 -14 94–103
1 -16 108–113
1 -20 127–133
1 -24 158–167
1 -32 245–258
O-Ring Boss Torque Values
Size
ft-lb
min–max
Assembly Steps
-02 6–7
1. Verify that the port, O-ring, sealing surfaces, and threads are clean and free of damage.
2. Lubricate the threads and the O-ring with 10W hydraulic
fl uid.
3. For an adjustable ORB, completely back o ff the locknut and washer.
4. Hand tighten the fi tting until it contacts the port spotface. Point the elbow or tee in the desired
direction and hold.
5. Torque to speci fi cation.
NOTE: Torque values speci fi ed are for threads lubricated with 10W hydraulic fl uid.
-03 8–10
-04 13–15
-05 17–21
-06 22–25
-09 40–43
-10 43–57
-12 68–75
-14 90–99
-16 112–123
-20 146–200
-24 154–215
-32 218–290