Page 9
Oberon™ Profile NZ / WZ - Rev. A
© 2016 Blizzard Lighting, LLC
Connection With Mains
Step 1:
Connect the fixture(s) to the mains with the supplied power cord.
The connection must be
connected to ground (earth).
Step 2:
You can use
PowerCon™ compatible
interconnect power cables
to safely power link up to 5
Oberon™ Profile fixtures at
100-120V.
Mounting & Rigging
This fixture may be mounted in any SAFE position provided there is enough
room for ventilation.
Mount the fixture using a suitable “C” or “O”
type clamp. The clamp should be rated to hold
at least 10x the fixture’s weight to ensure
structural stability. Do not mount to surfaces
with unknown strength, and ensure properly
“rated” rigging is used when mounting fixtures
overhead.
Adjust the angle of the fixture by loosening both
knobs and tilting the fixture. After finding the
desired position, retighten both knobs.
A safety cable MUST ALWAYS be used.
Gobo Holder
Take out the gobo frame, loosen the screws, insert the gobo and re-tighten the
screws. When complete, insert the gobo frame into the slot.
Color Gel Frame
Loosen the screws, insert a color gel sheet, and re-tighten the screws. When
complete, insert the gel frame into the slot.
AC100-240V, 50/60HZ
