Blitz Junior Jack 0, Инструкция по эксплуатации и список запасных частей

Страница: 14 / 22

Instruction Manual for Mobile Jacks
14
5.4 Lifting, Lowering, and Transporting Loads
DANGER
Danger to life, risk of injury from lifted vehicles
 Only load lift and load pick-up devices centrically by positioning the center of gravity in the
middle.
Safety Notes
 Always keep the movement range of the lift free.
 Keep the movement range of the load and the load pick-up devices free.
 Complete lifting of vehicles with one or more lifts is not permitted.

Always shut down and secure the lift immediately in case of malfunction. Always have
malfunctions repaired immediately.
 Do not operate the lift with compressed air containing condensate or dirt.
 For work with strongly adhesive underbody sealants or lacquers, cover the piston rod.
 Keep the piston rod and the pins of load pick-up devices free of sand and dirt.

Disconnect the lift from the compressed air supply at the end of work or before longer breaks.

Remove the removable pump rods after each work process.
CAUTION
Damage to lifts and vehicles from load pick-up devices and extended piston rods

Piston rods must always be completely retracted when entering or leaving workshop pits and
lifting platforms.
 A sufficient distance must exist between load pick-up devices and vehicle.
Considerable longitudinal forces can occur when vehicle axles are lifted.
 Disengage the handbrake and shift to idle, so that the wheels can roll.
Raising a vehicle

Lift the vehicle slightly with the lift at the load pick-up point.

Check for safe support and secure seating of the vehicle.
 Lift the vehicle to the desired height.
 Secure the vehicle against rolling off, for example with drag shoes.
 Secure lifted vehicle with supporting bridges/A-frames.
Lowering the vehicle
 Remove the roll-away protection from the vehicle.

Lift the vehicle slightly with the lift and remove the supporting bridges/A-frames.

Lower the vehicle slowly.
 Retract the piston rod [1] completely and make sure that the support plate is on the piston rod.
Transporting vehicle parts
 Position the vehicle part on a lift with a suitable transmission plate in centered position.
 Secure the vehicle part with chains or belts.

Retract the piston rod [1] completely and transport the vehicle part.