Press this button to remove the control panel.
Press this button long to turn on or off the power.
7. BASIC OPERATIONS
1) PANEL RELEASE BUTTON (REL)
15)POWER ON/OFF BUTTON
7) DISPLAY BUTTON (DISP)
17)MODE BUTTON (MODE)
For RDS models:
Press this button to view other information such as clock , RDS information, band and frequency ...etc.
For Non-RDS Models:
Press this button briefly, the VFD will display the clock for about 2 seconds, then return to previous
display mode.
Clock Adjustment
Under clock display mode, press DISP button until the VFD flashes, press Tuning Up Button to adjust
hour and Tuning Down Button to adjust minute.
CLOCK ADJUSTMENT (Only useful for NON-RDS Model)
Press this button to select Radio, Tape, CDP(MP3) or CDC/Aux In modes.
The available selections depends on version:
Radio Cassette Player:
Radio > Tape > CDC/Aux In(Optional)
Radio CD/MP3 Player
Radio > CDP > CDC/Aux In(Optional)
The RESET button is located on the main unit (as shown on the diagram). To press it vertically with a
ballpoint pen or metal object will activate it. The reset button is to be activated for the following reasons:
Initial installation of the unit when all wiring is completed.
All the function buttons do not operate.
Error symbol on the display.
RESET BUTTON
Note:
If press RESET button, the unit still cannot function normally, please use a cotton swab
soaked in isopropyl alcohol to clean the socket on the back of the control panel.
8. AUDIO OPERATIONS
6) VOLUME UP/DOWN BUTTON
13)FUNCTION SELECT BUTTON
Press this button to select desired audio function.
While the selected function is displayed, turn Volume Knob to adjust the level within 5 seconds,
otherwise the unit will return to volume adjustment mode.
2) MUTE BUTTON (MUTE)
Press this button to mute the sound. Press it again to resume listening.
14)PRESET EQUALIZER BUTTON (PEQ)
Press this button to toggle the following EQ setting:
FLAT->CLASSICS->POP M->ROCK M->DSP OFF
At DSP OFF mode, EQ will be controlled by Bass/Treble setting.
10)BAND/LOUDNESS BUTTON (BND/LOUD)
Press the Band/Loudness Button long to switch the loudness on or off. When Loudness is on, display
will show 'Loud On' for a few seconds.
ORDER OF FUNCTION:
VOLUME(VOL) -> BASS(BAS) -> TREBLE(TRE) ->BALANCE(BAL) ->FADER(FAD)
Press these buttons alone to adjust sound level, use this button with Function Select Button to
adjust the level of Volume, Bass, Treble, Balance or Fader.
NOTE:
In VFD button short press this button to toggle dimmer function. This will change the
brightness of VFD three level can be selected.
E - 8
RE
SE
T
