The carrier rod is made from duraluminum pipe. The large fixing ring that is mounted on its
lower end is used for connecting the pipe with the intermediate connecting rod.
The electronic block consists of a plastic box in which is mounted the metal detector’s
electronics. The control and indication appliances lie on the front panel, the back panel and the
bottom of the box.
The handle is part of the carrier rod and is coated with soft and solid foam.
For better stability, the armrest is made from duraluminum.
The power supply module consists of a plastic box in which is mounted the battery. On the
front panel of the box is mounted connector for plugging of the battery to the battery charger
(is available in the standard package with NiMH modifications), so that the charging of the
battery could be carried out when needed.
The intermediate connecting rod is made from duraluminum pipe. At its upper end it is
connected by the large fixing ring to the carrier rod – it fits into it, while at its lower end it is
connected to the lower connecting rod by the small fixing ring.
The lower connecting rod is made from carbon, so that it does not interfere with the normal
working mode of the metal detector. At its upper end it is connected by the small fixing ring to
the intermediate connecting rod – it fits into it, while at its lower part ends with a plastic
nozzle by which is connected to the search coil.
To not affect the intermediate connecting rod on the work of the metal detector because it is
made from duraluminum, ie metal, it is recommended that the lower connecting rod to be
inserted in the intermediate connecting rod to a situation in which remain at least 20-30
centimeters away from the top of the search coil to the small fixing ring.
To quickly and easily set the desired total length of the carrier construction, the intermediate
connecting rod has openings at different levels, one of which, according to the user are inserts the
fixed mechanism type bud, available on the lower connecting rod.
The search coil is connected to the plastic nozzle of lower connecting rod via the plastic bolt
and nut. Between the ears of the search coil and the plastic nozzle of the lower connecting rod
put emollient and fixed rubber type washer, which prevent ears of the search coil from
deformation and breakage when tightening. Thus, the search coil can be installed and removed
repeatedly from the lower connecting rod.
The search coil via the socket of the connecting shielded cable, is connecting to the connector
mounted on the rear panel of the electronic block.
If necessary to change the position of the search coil to the lower connecting rod (change the
working angle during working with the metal detector or folding to carry and transport) is
necessary to loose coupling fixing by a plastic bolt and nut and after the new setting, it can be
tight to be fix the search coil in the new position.
Changing the working angle in tight situation can lead to breakage of the ears of the search coil,
deformation of the ears and the search coil or a fatal frustration of the search coil and changes its
parameters.
When changing the working angle of the search coil to the lower connecting rod must be
monitored for the presence of an advance of the bottom of the connecting shielded cable of the
search coil to keep it stretched too much as this can cause damage its.
Recommended always to provide a small advance of the connecting shielded cable of the search coil
in its lower part, just above the nozzle during which it comes out of the search coil.
For fixing the bottom of the connecting shielded cable of the search coil, is used included in the
package fixing patches type velcro.
BLISSTOOL LTC48X -
User Guide (version EN201008241400)
Page 9 of 28
