20
21
information
i
information
i
To enter the open channel mode
Switch the pager off.
Press and hold button
and then press the power
button
.
Release the buttons.
To return to normal operation momentarily press the
power button
.
To replace the clip
Place your thumb on top of the clip and, using a
screwdriver, pull the locking tab away from the pager
body.
Whilst pressing the clip towards the pager body, rotate it
anticlockwise by 90° and gently pull it away from the
case
Open channel is a diagnostic mode
that allows the pager to display
information from all transmitted
calls. This is a 3 digit information
code followed by the identity code of
the pager being called.
The pager will display its software
title and, after a short while, the
first 8 function digits.
The remainder of the function digits
are displayed and the pager will
enter the open channel mode.
The thumb pressure avoids placing
too much strain on the clip
mounting.
Never rotate the clip without lifting
the tab as you will damage the
case.
To fit the new clip hold it 90° to the pager case and
insert it into the aperture.
Lift the locking tab, and whilst applying pressure, and
rotate the clip clockwise until it “clicks” into position.
Please note:
Under certain circumstances your pager can be subjected
to electrostatic discharge. This can cause the unit to reset
and go through the start-up sequence before returning to
normal operation.
