Cornical
™ - V3
© Blichmann Engineering, LLC 2020
For replacement parts, visit: blichmannengineering.com/genuine-replacement-parts
8
Install the keg plain lid hatch as shown in Fig. 5. Pull the pressure relief valve to relieve any pressure and then invert
the keg. Remove the conical bottom and replace it with the keg bottom as per the previous instructions. Reinvert the
keg, connect a CO2 fitting on the gas in post and purge the air from the top of the keg as described previously.
Pressurize the keg for carbonation and check for leaks at the band clamp, keg posts, and the lid hatch area. Correct as
needed. That’s it!!
Optional wall hanger (BE-000933-01)
is available and sold separately
Optional NPT Spunding Valve is perfect for the
Blichmann Engineering™ Cornical™ Unitank
Accessories
After ensuring all of the yeast sediment has been expelled from your fermentor, you will need to measure the beer level in
the fermentor to ensure it is less than 5 gal so that it doesn’t spill when you remove the cone bottom. To do this connect the
sanitized ½” hose to the outlet of the racking arm with a clamp. Depressurize the fermentor by pulling the pressure relief
valve and lock it open. Then hold the open end of the hose above the top of the fermentor and slowly open the racking
valve. The beer level will equalize at the level inside of the tank. See Fig. 13. If the beer level is above the 5 gal mark
simply drain some beer from the racking valve hose. Then close both the racking and pressure relief valve and remove the
hose.
