BrewEasy™ Compact NPT V1
© Blichmann Engineering, LLC 2021
For replacement parts, visit: blichmannengineering.com/genuine-replacement-parts
4
Step Four (Optional Recirculation Kit):
To install the flow meter onto the side of your kettle, gather the flow meter, sparge tube port bulkhead, retaining o-rings,
and the retaining washers. Place one o-ring and one retaining washer on the threaded side of the bulkhead, and insert
the threads through the inside of the upper hole on the right side of the kettle. The threads should be facing outward.
Install the remaining retaining o-ring and retaining washer on the outside of the kettle. Then, screw the bulkhead into
the stainless steel elbow of the flow meter. No thread tape is required.
Kettle wall
Step Three:
In the lower hole on the back of the left of the kettle, install the temperature probe as shown in the exploded view
below.
If you purchased your system without a controller, install the included Brewmometer™ in the 1/2” hole in the front of
the kettle.
TEMPERATURE SENSOR ASSEMBLY
Number
Part Number
Description
1
BE-000882-01
Sanitary Nut
2
BE-000882-01
Sanitary Nut Inner Seal
3
BE-000882-01
Sanitary Nut Outer Seal
4
BE-000013-00
Bulkhead O-ring -113
5
BE-001474-00
Weldless Captive Bulkhead
6
BE-001511-00
Captive Nut O-ring
7
BE-001475-00
Captive Nut
8
BE-001500-00
Temperature Sensor Probe
1
2
3
Kettle Wall
with ½” Hole
4 5
6 7
8
To Temperature
Probe Port
Inside Kettle
Outside Kettle
COMPLETE TEMPERATURE SENSOR ASSEMBLY
CAUTION:
• Do not pull sensor by cord, pull by stainless sheath only.
• Do not remove sensor when kettle is full of liquid without
optional thermowell.
