BLEC CP Series, Инструкция и каталог запасных частей

Страница: 22 / 38

22
SECTION 8 - OPERATING BLEC CULTI-PACK SEEDER
MODELS - CP36/CP42
OPERATING
The combination CULTI-PACK SEEDER and POWER TILLER has been designed for the accurate
seeding incorporation on top soiled areas, with a clean tilth free from large debris and stones.
DO NOT OPERATE ON STEEP BANKS OR WHERE THERE IS A RISK OF TIPPING OVER OR
RUNNING ON.
Before starting, plan your operation. On small areas, we recommend you seed the outside area first,
by seeding at least 2 widths of the machine. This will give you an area for turning on when seeding
the middle.
ON LARGE AREAS
Seeding can be started down the middle, continuing outwards.
The seeder can be operated by either standing on the rear footplate or by walking behind the seeder.
The footplate is used mainly for working up slopes or on very soft soil. When the footplate is not being
used it can be folded up.
STARTING WORK
1. Start the engine.
2. Select forward gear, approximate travelling speed :- around a fast walking pace, 3 -
5 mph / 5 - 8 kmh.
3. Make sure the hopper is filled with clean seed and the lever is in an OFF position.
4. Seed rate cam gauge is positioned at required setting. ( See Calibration Section ).
5. Position yourself behind the seeder, either on the footplate or standing on the ground.
Check the handlebars are at the correct height, adjust by slackening the clamping
bolt, then lift of drop to desired height.
6. Hold onto handlebars and engage clutch.
7. You will notice when the machine is travelling, steering is easily controlled by moving
the handlebars to either side. It may not be necessary to use slewing clutches when
turning every time.