11
SECTION 7 - PREPARING FOR USE
BLEC CULTI-PACK SEEDER
MODELS - CP36/CP42
ASSEMBLY
The
BLEC CULTI-PACK SEEDER
unit will be assembled, lubricated and ready for work if supplied
with a recommended power tiller equipped with safety devices.
However, if the seeder requires fitting to a power tiller, please follow the directions below:-
Step 1.
Fitment of cast ring roller drums to tiller axle. (
See Photos 2A & 2B
)
·
This operation will require 2 people for safety.
·
Please find level, hard surface. Stand the tiller on the wheels.
Remove the pin and clip on one side axle.
·
Raise one side of the tiller to allow the wheel to be removed.
·
(
See Photo 2A
).
·
position the cast ring drums with welded lip side towards shaft.
·
Rotate drum until the hole in the axle lines up with the hole in the drum.
·
Then line up the axle with the tube and slide on until the edge of the drum is
close to the chain case and also to the nearest hole in the axle.
·
Secure with the pin and clip.
·
Repeat same process with opposite side drum.
Содержание CP Series
